Kuryakyn6706 Motorcycle Lighting Accessory: Tour-Pak Lid Light, Rear LED Running/Turn Signal/Blinker/Brake Lights for 2014-19 Harley-Davidson Motorcycles, Chrome, One Size

This product is great. Instal could have been done in 20 mins but I triple check everything.LED's look like stock on the back of my 2014 Limited.Things to make application easier .Loosen back left and right luggage rack, only need about 1/2 inch to lift to slide light in will make your life much easierWiring routing is easy especially the Y they give you.At the pitch point if you feel potential for pinching add another cable holder just to push the wire out of the way( you will understand once you are done)Lights are break ,turn , running and flashers .One more thing the tape is strong make sure you line it up properly. once on you don't want to be playing with it .

Very easy install. I ran my wire into the trunk lid. I drilled a small hole into the lid, after running the wire through, the light itself covered up the hole once sticking the light on. I just hooked up the running and brake lights only,, it is a perfect light up top to aid in perfect eye level visibility to motorists behind me. The light is very bright and the brake light is awesome bright.I recommend this product,, not only for great looks but for additional safety.

Très bon produit

The instructions are clearly written, the wiring is flawless, the finished look is great and the lights perform flawlessly. It took less than an hour to complete. I installed this light on my after-market tour pack and it fit perfectly. However, I did not use the stick-on, zip tie clips, but merely routed the wire from the light under the passenger backrest, then zip-tied it to the tour pack bracket (leaving sufficient length to allow the lid to open without binding), and then routed it under the seat. I also wrapped some electrical tape around the un-insulated 1/2” of wires at the light fixture. I’m very pleased with this addition to my 2019 SG.

Great addition to your pack. I put it on my chopped tour pack. I ran wires internally behind back rest pad. I wasn’t able to de pin the plug, so I had to make larger holes, but I used rubber grommets to plug them. Would have been cleaner with smaller holes, but they are both hidden by the seat pad. Otherwise easy plug and play install.