ORXPLUS Tools Deburring External Chamfer Tool, Tungsten Blade, Deburring Drill Bit, Remove Burr Tools Suitable on Stainless Rod, Thread and Pipe for Fit 1/8"-3/4"(3mm-19mm)

Why did you pick this product vs others?:Always did my chamfers by grinder/flap wheel and decided to try a dedicated tool. Works great, quick and clean.

Works as advertised.

I had to cut down the studs on my rear axle as the ARP ones were too long to use with closed lugs nuts. The was able to go through all ten studs and chamfer down the sawed off end on all ten studs. I used a regular cordless drill set to the lower speed setting (1 instead of 2 for my older Dewalt) and the tool worked its magic on the ends.I'm not sure how many more studs it would have in it, but I know that it went through ten hardened studs with great results and still has material left in it for more work down the road. It's in my drill bit drawer now for use on the next round of all-thread, studs, or bolts I need to chop down and chamfer.The pictures show the first stud and the last stud I used this on as well as what the starting point was for each stud.

Not as sharp as I would like but with the correct amount of pressure it works pretty well.

After reviewing many others, I decided to buy this ORX Plus Tools Deburring Drill Bit for bolt sizes 1/8"-3/4".It has saved me a lot of time on projects, maintenance and repairs. I mainly use it on threaded bolts. It's easy to use. It a quick attachment. The price is a little high but worth it. It's been nine months and it still works like new. I use a little bit of oil every now and then, just like with my regular drill bits. I have used it over forty times and always gets the job done nicely.

What a surprise to use a cheap tool that actually works. Cuts like a hot knife through butter. Nuts thread on perfectly. Used on m6 and m10 bolts.

Ok

Worked as described but wore out quickly. We ended up finding a better tool.